Things to take care of when getting steel welding repairs for your horse floats

Precautions when getting steel welding repairs for your horse floats

Horse floats should be regularly checked for fitness to ensure the safety of the animals being transported in them. There are many different elements that need to be inspected to check the safety of a horse float. The most important of these elements is the steel welding. If the welding has come loose or it not strong enough, the horse float will no longer be able to bear the weight of all the horses and will collapse resulting in severe injuries to the horses.

Steel Welding Repair professionals in Sydney recommend that whenever you encounter a problem in steel welding, it is important that you repair it immediately. Delaying a damaged steel welding is a big risk and there are many factors that the owner should consider while getting repairs. Some of the things that should be taken care of when getting steel welding repairs in Sydney are:

1.     Pure from impurities

Whenever you go for a steel welding job in Sydney, it is important to ask the professional whether he or she has prepared the metal properly before welding or not. This means that all types of impurities either rust, dirt, paint, or other contaminants, everything should be removed from the metal. Even after the weld is done, use a powered wire brush to clean the area.

It is necessary because if the impurities are left inside the metal, they might compromise the quality of repair. There will be chances that the weld opens up again in future and wastes all your money.

2.     Rules for speed and direction

The procedure of steel welding in Sydney requires a particular speed, angle, and direction of the gun. When welding, the gun should be placed at 10-15 degrees and in a direction that pushes the weld. The distance in between the rod tip and the work piece should be 1/8 inch while the arch length should not exceed the diameter of the core of electrode.

The speed should be according to the manufacturer’s instructions, where the travel speed should not be too slow as to result in more deposition of metal. Similarly, if the travel speed is too high it produces a shallow weld. Mostly the speed is kept at less than 40 inches per minute.

3.     Cracks in welds

It is very important to inspect the weld for any cracks. Any cracks after welding can lead to the failure of repair. Cracks can be avoided by taking care of a few of these points:

●       Do not preheat the metal before welding, this is only required when the steel being weld has more carbon and alloy content.

●       Perform proper reinforcing of a weld crack.

●       Try filling the crack till the end.

●       Make the welds wider than they are deep.

●       Avoid grinding cracks to the bottom before welding.

These are some simple points that should be looked for when going for steel welding in Sydney. Keeping an eye on the repairs is the simplest way of preventing the need for any future repairs. Save your time and money, and make sure to always inspect the repairs properly before taking your horse float back.